Speaker
Description
The new digital electronics of the four Radio Frequency
(RF) plants for Elettra 2.0 (E2.0) is fully designed in house,
both hardware and firmware. The Digital Low-Level Radio
Frequency (DLLRF) works on a non-IQ sampling technique
and it is benefiting from the huge internal development
of a System On Chip (SoC) Field Programmable Gate Array
(FPGA) boards realized for the electron beam position
monitor electronics. Each RF plant will have its own machine
protection system based on FPGA board to minimize
the interlock intervention time. Initial tests of these new
electronics have been carried out during last run of Elettra,
however the complete commission is carried out using
the RF power plant available in the laboratory. This paper
presents the design choices and the performed tests that
confirm the achievements of the system’s specification.
Footnotes
*cristina.pasotti@elettra.eu
| In which format do you inted to submit your paper? | LaTeX |
|---|---|
| Preprint marking on your proceeding paper | I wish my paper to be marked as preprint. |
| I no longer wish to present this contribution, please withdraw it. | Keep my contribution |